-Getting started
-PVC Clamp
-Gobar
-PVC Gobar
-Gobar Deck
-Sandpaper Cutter
-Sanding Block
-Fret File
-Bending Jig
phone/fax:
(808) 847-1541
718 Puuhale Rd.
Honolulu, HI
96819
|
PVC Ring Clamp
A very cheap and effective clamp. A 3 foot length of PVC pipe will make over 100 clamps!
Especialy good for gluing up tentalone to sides
where most clamps are too bulky.
|
|
PVC Ring Clamp
Materials:
1. Scrap length of schedule 40 PVC pipe with 1 5/8" outside diameter and 1/8" thick walls.
Steps:
1. Cut a piece of PVC length into multiple 5/16" wide rings.
2. Cut saw slot thru ring at only one place
|
|
|
|
|
In Use:
1. Lower ring at left cut from scrap 1 5/8" diameter PVC pipe (cut plenty)
2. Upper ring at left shows saw cut thru ring at 1 place. Cut it anywhere, but only in one place.
3. Ring in use holding in tentalone to sides for gluing purposes.
|
|
|
|
|
In Use:
1. Lower ring at left cut from scrap 1 5/8" diameter PVC pipe (cut plenty)
2. Upper ring at left shows saw cut thru ring at 1 place. Cut it anywhere, but only in one place.
3. Ring in use holding in tentalone to sides for gluing purposes.
|
|
|
|
|
